







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Monrovia, CA: What to Expect and What They Cost
Paver driveways in Monrovia, CA typically run $7,000 to $18,000 for a standard two-car driveway, and most projects finish in four to seven working days from demo to final joint sand. The job is a full excavation and base build, not a resurfacing: we pull out the old surface, compact a graded aggregate base, set edge restraint, lay the pavers, and run plate compaction over the finished field. Call (888) 271-7872 for a free on-site estimate with a written line-item quote.
How We Build a Paver Driveway, Stage by Stage

Every driveway follows the same sequence, and the stages matter because a shortcut in any one of them shows up as settled pavers two winters later. Here’s what actually happens, in order.
Stage 1: Layout, demo, and haul-off (day 1)
We mark the driveway edges, confirm the slope away from the garage door, and cut out the existing concrete, asphalt, or gravel. A standard two-car slab is roughly 10 to 15 cubic yards of debris, and the dumpsters land before the demo starts. You’ll confirm the final width and any flare at the street apron at this point, because changing footprint later means re-excavating. This is also when we check what’s under the old surface: root intrusion, a failed subbase, or buried irrigation are common finds on older Monrovia lots.
Stage 2: Excavation and base prep (day 1 into day 2)
We dig to a depth of about 9 to 13 inches depending on paver thickness, then build up a compacted Class II aggregate base in lifts. Each lift gets watered and plate-compacted before the next goes down. On sloped approaches we may add geotextile fabric to keep the base from pumping into soft subgrade, particularly where expansive clay has been disturbed.
Stage 3: Edge restraint and bedding (day 2)
Concrete or steel edge restraint goes in along both sides and the street apron. That’s the piece that keeps the field from spreading under tire load. Then a screeded layer of coarse bedding sand, usually about an inch, sits under the pavers. You’ll finalize paver color and laying pattern before this stage; once the field starts, changing the pattern means pulling up what’s laid.
Stage 4: Paver installation and cuts (days 3 to 5)
The crew lays from a chalk line, keeping courses square to the garage door so the eye reads it straight. Field cuts at the edges and around the apron happen on a wet saw. Expect some cutting waste, usually 5 to 8 percent on a standard layout and more on a herringbone field that hits curves.
Stage 5: Compaction, joint sand, and cleanup (days 5 to 7)
A plate compactor runs over the whole field, then polymeric joint sand goes in and gets vibrated down into the joints. We sweep, blow off the dust, and walk the finished driveway with you. If this is part of a bigger Driveway & Pavers in Monrovia plan, the sequencing with patios and walkways happens here. Final inspection and cleanup typically close out the same day.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Most of the decision comes down to paver material, thickness, and pattern. Here’s the honest trade-off on each.
- Concrete pavers (standard 60mm): The workhorse for driveways. Interlocking units rated for vehicle load, they run lower on material cost than clay brick and hold color well. The units are manufactured to a consistent size, which keeps joints tight. This is what most Monrovia driveways end up using.
- Clay brick pavers: Warmer look, especially suited to the older Craftsman and Spanish Colonial stock around Old Town. Higher material cost and more breakage on delivery, but the color goes all the way through the unit and it ages well. Best for homes where the driveway is visible from the street and the design matters as much as the function.
- Permeable pavers: Open-graded units with wider joints and a drainable base. Costs 15 to 25 percent more than standard, but it moves stormwater through the surface instead of sheeting it toward the garage. Worth considering on flatter lots with poor drainage.
- Thickness: 60mm handles passenger vehicles. If a heavier truck, trailer, or RV parks on the apron, step up to 80mm on that section.
- Pattern: Running bond and stack bond are the fastest to lay and the least wasteful. Herringbone and basketweave look better and lock tighter under turning tires, but they use more material and take longer.
What Paver Driveways Cost in Monrovia, CA

Paver driveway installation in Monrovia runs $7,000 to $18,000, with the typical two-car job landing near the middle of that band. Five things push it up or down:
- Square footage: A single-car apron at roughly 250 square feet sits near the $7,000 end; a three-car driveway with a turnaround can pass $18,000.
- Material and pattern: Standard concrete pavers in running bond are the low end. Clay brick in herringbone is the high end, and permeable systems carry their own premium.
- Existing condition and demo: A sound concrete slab that comes out clean is cheaper to demo than a cracked, root-bound, or settled base that has to be dug deeper.
- Base repair and drainage: If the subgrade is soft or the driveway has no drainage, fabric, additional base, and a channel drain add cost.
- Edge conditions and access: Tight hillside access, a narrow gate, or a long haul distance adds labor and slows the job.
A written estimate from us itemizes excavation, base, edge restraint, pavers, joint sand, and haul-off. It also lists what’s excluded, and the usual exclusions are drainage improvements, retaining wall work, and any subgrade repair found after demo. Upfront pricing means the number we quote is the number you pay unless the scope changes, and no change order happens without your sign-off.
See the difference
Before
After
Before
After
Before
AfterWhat Monrovia Homes Specifically Do to This Job
Monrovia’s terrain splits the work in two. Down on the flat grid around Old Town and along the Myrtle Avenue corridor (ZIP 91016), the driveways sit over older clay and expansive soils, and 1920s-era bungalows often have an original garage slab that has settled or cracked from root action. Up in the foothills, lots climb into the San Gabriel foothills interface, and a driveway there is really a grading project: slope, drainage, and sometimes a retaining wall carry more of the cost than the pavers do. The wash and canyon mouths above town are the county’s debris-flow watch zones, so drainage is not an afterthought on any hillside driveway. The rain-shadowed climate here means long dry seasons followed by hard atmospheric storms, and a drive that sheets water toward the garage will show it every February. If your driveway is part of a broader Driveway & Pavers project, the same soil and slope facts drive the scope. Most of the driveways we build in Monrovia settle around three failure patterns: settled bases, water pooling at the apron, and joint sand washing out.
Serving Monrovia, CA – Our Local Coverage Area
We serve Monrovia and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Paver Driveways in Monrovia

A standard two-car paver driveway takes four to seven working days from demo to final compaction, weather permitting. Larger jobs, hillside grading, or additions like a drainage channel can stretch that to two weeks. Call (888) 271-7872 for a schedule estimate specific to your driveway.
Yes, in most cases. Monrovia requires a permit for driveway construction or replacement within the public right-of-way, and grading of a sloped driveway may trigger additional review. We pull the permits and manage inspections, and we’ll confirm the requirement for your specific address before demo. Call us to walk through the permit path for your lot.
No, not on a permanent basis. Overlaying pavers on a cracked or settled slab traps the failure underneath and the pavers will reflect it within a season or two. Full excavation and a new compacted base is the only way to get a driveway that holds. Call (888) 271-7872 for an honest assessment of your existing surface.
Paver driveway installation in Monrovia runs $7,000 to $18,000 for a standard job, with the final number driven by square footage, paver material, pattern, and any base or drainage repair. A written line-item estimate is free, and it separates the base work from the paver cost so you can see what’s driving the number.
The 730-Day Done Right Promise covers our workmanship for two full years. If the pavers settle, a joint fails, or the edge restraint gives, we come back and fix it. Material warranties come from the paver manufacturer and vary by product. Call us to review the warranty terms for the specific paver you’re considering.
Get a Free Paver Driveway Estimate in Monrovia
Call (888) 271-7872 to schedule a free on-site estimate for paver driveways in Monrovia. A live person answers around the clock, and we’ll set a time that works for you. On the visit we measure the driveway, check the existing surface and drainage, and hand you a written line-item quote, usually within a day or two. If you’re planning a larger scope, pair this with ADU Design & Permitting in Monrovia or a Garage Conversion ADU in Monrovia while we’re on site.
Written by the team at Groundwork Construction Co.












