







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in South San Jose Hills, CA
Asphalt Driveways & Resurfacing in South San Jose Hills usually runs $4,130 to $10,620 for a new asphalt surface, and $295 to $825 for sealing an existing one. Most residential jobs are finished in two to four days, with a 24 to 48-hour stretch where nobody drives on the new surface. It’s the right call for the long private driveways we see off ZIP 91792, where a half-acre to two-acre hillside lot can mean 80 to 200 feet of run from the street to the garage. Call (888) 271-7872 and we’ll set a free on-site estimate.
How we pave an asphalt driveway in South San Jose Hills, stage by stage

We don’t turn a driveway loose on a crew and hope. The sequence below is what actually happens, and the decisions you’ll make along the way are named so there aren’t surprises.
Stage 1: Site walk and grading plan (day 1)
We measure the run, check the existing base, and look at where water wants to go. On sloped lots here, drainage is the whole ballgame. You’ll decide the drive’s width (10 feet minimum, 12 feet if you want two cars to pass comfortably), the turnaround or apron configuration, and whether the layout stays put or shifts. This is the stage where a hillside lot gets a real crown and fall plan instead of a flat slab draped over a grade.
Stage 2: Demo and subgrade prep (day 1 into day 2)
Old asphalt, gravel, or failed concrete comes out, and we cut down to a compacted subgrade. Crushed aggregate base gets laid and rolled in lifts, typically 4 to 6 inches compacted for a residential drive. If you have clay soil holding water underneath, we address it here. That’s a call you make with us on site, because the fix is a base repair, not a paving one.
Stage 3: Hot-mix paving (day 2 or 3)
The asphalt goes down hot, spread and rolled while it’s still workable. Residential driveways usually take 2 to 3 inches of compacted hot-mix over the base. Thickness is a decision point: 2 inches is fine for passenger cars, 3 inches is the call if you park a truck, trailer, or boat on the drive. Edges get shaped and compacted here too, not left ragged.
Stage 4: Cure and traffic hold (day 3 into day 5)
New asphalt needs time. Foot traffic can usually go on it after 24 hours, vehicles after 48 to 72 hours depending on the weather. On a hot week in South San Jose Hills, we sometimes tell you to keep weight off a bit longer. You’ll want to move cars before the paving crew arrives, and we’ll tell you the exact window.
Stage 5: Sealcoat (30 to 90 days out)
Fresh asphalt needs to cure before it’s sealed, typically 30 to 90 days. That first seal coat protects the binder and starts the maintenance clock. After that, resealing every two to three years is what keeps an asphalt driveway out here from turning gray and brittle.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The asphalt options you’ll choose between
- New asphalt over new base or resurfacing over sound base. Resurfacing (a new asphalt layer over an existing sound one) is the cheaper path, but only when the base is still solid and the cracks aren’t structural. If the base has failed, resurfacing just hides the problem for a year.
- 2-inch vs 3-inch compacted thickness. Two inches handles cars. Three inches is worth the extra cost if you park anything heavier on the drive, and on the longer runs here, the difference in longevity is real.
- Standard hot-mix vs fiber-reinforced mix. Fiber-reinforced asphalt resists cracking better on drives that get sun-baked and then see Santa Ana wind events. It costs more per ton, but it’s the honest choice on an exposed hillside run.
- Edge treatment. Crushed rock shoulders vs. a concrete or paver border. The border holds the asphalt edge in place and looks sharp. Plain rock shoulders are cheaper and hold up fine if the grade is gentle.
- Sealcoat timing and finish. A single protective seal after cure, or a seal plus a second coat later. Some homeowners also want a tinted or matte black finish; we’ll tell you honestly if it’s worth doing.
For homes where the driveway is tied into a larger front-yard plan, the wider scope lives on our Driveway & Pavers service page, and you can see the full local scope on our Driveway & Pavers in South San Jose Hills page.
What Asphalt Driveways & Resurfacing costs in South San Jose Hills, CA

Here’s the honest range, line by line. These are the numbers we quote against, and the written estimate you get will reflect exactly which line items apply.
| Work | Typical range |
|---|---|
| Full asphalt driveway paving (new surface and base) | $4,130 – $10,620 |
| Asphalt resurfacing over sound existing base | $2,800 – $7,400 |
| Driveway sealing (protective coat) | $295 – $825 |
| Base repair or subgrade correction (add-on) | $1,200 – $4,500 |
Four things push a job toward the high end. Length and width of the drive is the biggest: a 60-foot run is one number, a 180-foot hillside run is another. Base condition comes second; if the subgrade has failed, we fix it, and that’s a line item. Thickness and mix grade push it too. So does access: a tight approach or a steep grade where the paving equipment can’t easily reach the work area adds labor. What’s included in a written estimate: demo, base prep, hot-mix paving, edge compaction, and cleanup. What isn’t included: sealcoat (that’s the later line above), retaining wall repair if the hillside is pushing on the drive, and drainage work that falls outside the drive footprint. No-hassle upfront pricing holds: the number you see is the number you pay, and the work carries our 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat South San Jose Hills homes specifically do to this job
This is the part of LA County where a driveway isn’t a driveway. Hillside lots of half an acre to two-plus acres, many still zoned for horses, mean a long private run from the street to the house, and that run lives on graded terrain that most neighboring cities don’t have. We’re working on 1960s to 1980s ranch and custom homes on those sloped parcels, and the failure pattern we see most often is a driveway that never had a proper base for its length. Seasonal clay-soil expansion on these hillsides works on the subgrade from underneath, so a driveway that looked fine in spring heaves and cracks by the end of a hot summer. The inland heat here, mixed with marine layer mornings and hard Santa Ana wind events, also bakes the surface and drives the cracking. On the long runs, water has a lot of distance to pick up speed, so drainage and crown get as much attention as the asphalt itself. We cover the whole of South San Jose Hills, and if the project is part of a broader remodel, homeowners often pair this with a New Detached ADU in South San Jose Hills or, on a tighter plan, with a Junior ADU & Interior Conversion in South San Jose Hills. Every crew that shows up is background-checked and in uniform, and our technicians have up to 12 years of experience.
Serving South San Jose Hills, CA – Our Local Coverage Area
We serve South San Jose Hills and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Asphalt Driveways & Resurfacing in South San Jose Hills

Most residential asphalt driveways take two to four days of active work, followed by 24 to 48 hours where vehicles stay off the surface. A long hillside run with base repair can push to five or six working days. Add 30 to 90 days for the first sealcoat after the asphalt cures. Call (888) 271-7872 and we’ll give you a schedule based on your actual lot.
In an unincorporated pocket like this, the rules are county rules, and they depend on whether you’re touching the right-of-way at the street edge, cutting a new approach, or changing drainage that affects a slope. Many residential repaves over the same footprint don’t require a permit, but anything that changes the street apron or the grade usually does. We’ll tell you on the site walk exactly what applies to your property and pull and pass what’s required. Call (888) 271-7872 for a free estimate.
Only if the base is still sound. We check for structural cracks, soft spots underfoot, and pooling water. If the base is solid, resurfacing over it saves real money. If it’s failed, resurfacing just hides the problem for a year. We’ll show you on site which category your driveway is in, and quote the honest version. Call (888) 271-7872.
Sealing a residential asphalt driveway here runs $295 to $825, depending on length and condition. On the long private runs common on hillside properties, expect the upper end. It should happen for the first time 30 to 90 days after new asphalt cures, and then every two to three years. Call (888) 271-7872 for an exact quote, free of charge.
Every asphalt driveway we pave is covered by our 730-Day Done Right Promise. If it isn’t right, we make it right, and that’s in writing. We also include the material grade in your written estimate along with a written line-item breakdown, so nothing about the job is left vague. Background-checked technicians arrive in uniform on every visit, and calls are answered by a live person 24/7. Call (888) 271-7872 to schedule a free estimate.
Get a free asphalt driveway estimate in South San Jose Hills
A free on-site estimate for asphalt driveways & resurfacing in South San Jose Hills starts with a call to (888) 271-7872. A live person answers any hour of the day, and from there we schedule a visit to measure the run, inspect the base, and talk through the options. You leave the visit with a written line-item quote and the material grade spelled out. No-hassle upfront pricing, 0% financing for 18 months, and $1,000 off projects over $10,000.
Written by the team at Groundwork Construction Co.












