







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Vincent, CA: What It Takes
Concrete driveways and concrete work in Vincent, CA typically run $4,500 to $12,000 for a full driveway pour, with most residential jobs finished in 3 to 5 working days from demo to first drive. That range covers a standard two-car replacement; longer service drives on acreage lots push toward the top. For an exact number on your property, call (888) 271-7872 and we’ll set up a free on-site measure.
With Vincent, it starts with the land
Vincent is an unincorporated pocket of the San Gabriel Valley, and the properties here reflect it. Mid-century single-story tract homes from the 1950s through the 1970s sit on small lots close to the 91722 core, but drive back toward the county edge and you hit detached workshops, long pull-through drives, and acreage parcels where the concrete run from the street to the shop is three or four times the length of a suburban apron. That changes the job. A drive that serves a heavy truck and a workshop doorway needs deeper base, tighter control-joint spacing, and mix design that holds up to point loads, not just a car rolling in and out.
Then there’s the heat. Summer afternoons here run well above 90°F, and a slab poured at 1 p.m. in July will flash-set and crack before anyone can finish it. We schedule most Vincent pours for early morning and use set retarders or shade curing on the hot ones. It’s the kind of thing that separates a slab that looks fine at year one from one that’s still tight at year fifteen.
What a concrete job in Vincent actually looks like, stage by stage

Concrete is unforgiving of shortcuts. Once it’s poured, the base under it is buried, and every mistake shows up two winters later as a crack or a sunken panel. Here’s how we run it so that doesn’t happen.
Stage 1: Site layout and the elevation call (day 1)
We mark the footprint, check the existing grade, and confirm where water needs to drain. In Vincent, that usually means sloping away from the garage and toward the street or a dry well, especially on lots where the old slab pooled. You’ll decide at this point whether the new drive keeps the same width or widens for a second vehicle or a trailer. This is also when we confirm utility locations before anyone digs.
Stage 2: Demo and haul-off (day 1 into day 2)
The old slab, if there is one, comes out with a breaker and goes into a dumpster. A 20-by-40-foot drive is roughly 20 to 25 tons of debris, so hauling takes most of a day on its own. If the existing base is sound and well-drained, we may keep it and recompact; if it’s pumping or has voids, it comes out too. You’ll see the subgrade before we cover it.
Stage 3: Base prep and formwork (day 2)
We excavate to depth, bring in and compact Class II base, and set forms to the finished grade. On Vincent properties serving a workshop or heavy vehicle, we go 6 inches of base and a 5- to 6-inch slab instead of the 4-inch residential standard. Rebar or mesh goes in at this point, and any expansion joints against the garage, walkway, or shop apron get set. This is where the job is really won or lost.
Stage 4: Pour, finish, and control joints (day 3)
The truck arrives early on pour day. We screed, float, and finish the surface, then cut control joints at roughly 10-foot intervals, or score them if you want a decorative pattern. Broom finish is standard for traction; a light salt finish or exposed aggregate is an option if you want texture. Curing compound goes on before we leave the site.
Stage 5: Cure and striping (days 4 through 7)
Concrete reaches most of its strength in the first week, but you shouldn’t park on it for at least 7 days, and heavy vehicles should wait closer to 10. We return to pull forms, backfill the edges, and confirm the joints opened cleanly. If you’re adding a garage or shop door, that hardware goes in after the slab has cured – which is where a Garage Conversion ADU in Vincent often pairs naturally, since the drive and the new living space can be sequenced together.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The concrete specs you’ll actually choose between
These are the decisions that move both the price and how the slab performs over a Southern California decade. We walk through each one with you on the estimate, but here’s the honest trade-off on the ones that matter most.
- Slab thickness: 4 inches is fine for a passenger car; 5 to 6 inches is right for an RV, a heavy truck, or a workshop apron. The cost difference per square foot is modest – the mistake of going too thin is expensive.
- Reinforcement: Welded wire mesh is the budget choice and works on light-duty drives. Rebar on a grid adds a few hundred dollars on a typical Vincent job and holds the slab together far better when the base shifts.
- Finish: Broom is standard and grippy. Salt finish costs a bit more and hides tire marks. Exposed aggregate looks sharp but can be harder on bare feet and harder to repair if a panel ever needs replacing.
- Color and stamping: Integral color and a light stamp can mimic pavers or stone, but at this scale the honest answer is often that a proper Driveway & Pavers install gives you a look that holds up better because it can flex. Belgard and Techo-Bloc pavers are what we typically spec when that’s the direction.
- Base depth: Class II at 4 inches is the minimum; 6 inches where the soil holds water or the drive sees heavy loads. On the older Vincent lots, this is where the money should go.
What concrete driveways cost in Vincent, CA

A full concrete driveway in Vincent runs $4,500 to $12,000. A driveway replacement – demo, haul-off, and new pour – lands at $5,000 to $14,000. Standalone slabs, aprons, and shop pads price per square foot and are usually quoted after the site measure. For a side-yard slab, a walkway, or a workshop pad, the number comes from the same measure; the driveway is only one piece of a broader scope we go through on our Driveway & Pavers in Vincent page.
The variables that push it toward the low or high end
- Square footage: A 20-by-20-foot two-car drive sits near the bottom of the range. A 20-by-50 service drive to a shop pushes it up.
- What’s already there: A solid base that can be recompacted saves the demo cost. A slab that’s cracking and pumping adds $1,500 or more in haul-off and re-base.
- Grade and drainage: Flat lots are cheap. Steep cross-slopes or a low spot that needs a retaining curb or dry well add real money.
- Spec grade: 4-inch broom-finished mesh is the low end. 6-inch rebar-reinforced with a decorative finish sits at the top.
- Permit scope: A straight replacement in Vincent is straightforward County review. A new driveway apron cutting into the street or grading that changes lot drainage can trigger more – and that review has its own cost.
What’s in a written estimate, and what isn’t
Our estimates are line-item and fixed: demo, haul-off, base material, reinforcement, slab thickness, finish, control joints, and permit fees when they apply. What’s not included – and what we tell you upfront – is anything that can’t be seen until the slab comes up, like a broken sewer line running under the drive or a buried utility box. If we find that, we stop, show you, and quote the fix before it goes any further. No change orders you didn’t approve.
See the difference
Before
After
Before
After
Before
AfterWhy Vincent jobs run a little differently than one town over
Since Vincent is unincorporated, nearly all construction here – including a straightforward concrete driveway – runs through LA County’s permitting and inspection process instead of a city hall. That has real consequences for scheduling. County Building & Safety plan checks and field inspections run on their own calendar, and a crew that doesn’t build that lead time into the schedule is a crew that leaves your forms sitting for a week. It also has a boundary wrinkle that catches out-of-area contractors: a project near the Covina or Azusa edge can shift from County to city jurisdiction block by block. We check which side of that line your property sits on before we pull anything.
The housing stock adds its own notes. Most of the 91722 core is mid-century single-story with attached garages, plus a growing share of newer two-story infill and ADU builds. On the older homes, we see a lot of original slabs that were poured before anyone thought about base depth – they’re cracked, heaved, and pooling water against the garage wall. On the newer ones, we’re usually pouring a fresh pad for an added shop or a longer drive. Either way, if you’re adding living space, most homeowners pair this with a New Detached ADU in Vincent and pour the drive once instead of twice. We handle both under one crew, so the sequencing works out.
Serving Vincent, CA – Our Local Coverage Area
We serve Vincent and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: concrete driveways & concrete work in Vincent

A standard two-car driveway in Vincent takes 3 to 5 working days from demo to first drive – demo and haul-off one day, base and forms the next, pour on the third, then form pull and backfill. You should stay off the slab for at least 7 days, and heavier vehicles for 10. If your job needs County inspection before the pour, add the inspection lead time to that window, and call (888) 271-7872 for a schedule you can plan around.
Most driveway replacements in Vincent require a County permit through LA County Building & Safety, since that’s the authority over unincorporated parcels. New driveway aprons that cut into the street, structural slabs, and any grading that changes drainage usually trigger a longer review. We handle the permit application and the inspection, so you’re not the one chasing it – call (888) 271-7872 and we’ll confirm what your specific parcel needs.
Expect $4,500 to $12,000 for a full pour and $5,000 to $14,000 for a replacement that includes demo and haul-off. A small side-yard slab or shop pad prices lower, and a long service drive on acreage goes higher because of base material and the square footage it covers. Call (888) 271-7872 for an exact quote – the on-site measure is free.
Yes, in most cases. A new slab can go in without touching landscaping, walkways, or structure if the existing base is sound and drainage already fails away from the house. Where the old slab is heaved against the garage or pooling water toward the foundation, we usually recommend pulling it so the base can be corrected underneath – call (888) 271-7872 and we’ll tell you straight which side of that line your job falls on.
Every concrete driveway and slab we pour in Vincent is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. That’s two full years on the workmanship, and we put it in writing on the estimate. Call (888) 271-7872 to schedule a free estimate and see the spec we’d propose for your property.
Get a free on-site estimate for concrete work in Vincent
We’ll come out, measure the driveway or slab, check the base and drainage, and hand you a written line-item quote with the spec spelled out and the price fixed. No surprise change orders. Vinyl-to-concrete, shop pads, aprons, and full driveway replacements across Vincent – one free visit, one straight answer. Call (888) 271-7872 and we’ll get it on the calendar.
Written by the team at Groundwork Construction Co.












