







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterWhat Is a Curbless Shower? A Straight Answer for El Monte Homeowners
A curbless shower is a shower with no raised lip at the entry: the bathroom floor runs straight into the shower floor, and water drains through a linear or center drain set slightly below the finished floor level. The finished tile is only the visible layer. Underneath it, the entire shower area has to slope toward that drain at no less than 1/4 inch per foot, which means the drain has to sit lower than the surrounding floor. If your El Monte home was built on a post-WWII concrete slab, that lower drain means cutting into the slab itself. That one fact changes the cost, the permit requirement, and the contractor you should hire. Call (888) 271-7872 if you want us to look at your actual floor and tell you what it’ll take.

Why a Slab Floor in El Monte Makes This a Concrete Job First
Most of El Monte’s housing was built between the 1940s and 1960s, and the dominant foundation type across that tract stock is slab-on-grade. There’s no crawl space, no joist bay to notch, and no easy way to drop a drain between framing. A conventional shower with a 4-inch curb hides the drain assembly inside a framed platform. A curbless shower has nowhere to hide it. The drain body has to sit recessed into concrete, and the surrounding slab has to be cut, chipped, and re-poured or packed to create that recess.
What that looks like on a real job: we cut and remove a section of slab around the drain location, expose the existing drain line, rework the trap and pipe to the new lower elevation, then rebuild the depressed pan with a sloped mortar bed before anything waterproof goes on top. On older homes, the drain line we expose is often original cast iron or an early clay lateral, and it can be at the end of its service life. Finding that out after demo, not before, is how budgets blow up. That’s a big part of why we plan the concrete scope and the plumbing scope together, upfront, before a hammer swings.
If your home sits on a raised foundation instead, the job is easier – the drain can often be dropped between joists by sistering framing. We check the foundation type on the first visit because it’s the single biggest cost variable in a curbless shower, and it’s the answer to why one neighbor’s quote is $5,000 and another’s is $13,000.
The Waterproofing Membrane Is the Part That Actually Matters
Homeowners fixate on the glass panel and the tile pattern. The membrane is what keeps the shower from leaking into the slab and the framing. In a curbless build, water has no curb to stop it, so the waterproofing has to be continuous across the entire wet area, up the walls, and tied into the drain flange with a proper clamping or bonding connection. A pinhole in that membrane won’t show up for a year or two, and by then it’s a rotten subfloor or a stained ceiling below.
Our background-checked technicians follow a staged inspection protocol: substrate prep verified, membrane installed and flood-tested, then the surface material goes down. Nobody tiles over a membrane that hasn’t passed its water test. The 730-Day Done Right Promise – if it’s not done right, we make it right – sits on top of that protocol, and it’s one of the longest workmanship guarantees in residential construction. Tile from Kohler and Moen fixtures look great; what keeps the build holding up is the layer underneath, built to last, backed in writing.

Do You Need a Permit for a Curbless Shower in El Monte?
Yes. Any penetration into the slab triggers a plumbing permit and inspection, and El Monte’s plan-check process reviews the scope before a permit is issued. That’s not a formality to work around – it’s the step that catches a bad drain elevation or an undersized trap before tile goes down. El Monte is a built-out city where almost every job is infill work, so plan-checkers know the local housing stock and they ask pointed questions about concrete cutting and drain relocation.
We handle the permitting step in-house and price it into the estimate, so the number you see is the number you pay. Discovering the permit requirement after demo, or scrambling to pull one after the slab is already cut, is a scenario we’ve heard from homeowners who called us after the first contractor walked off. No-hassle upfront pricing means the permit, the concrete, the plumbing, and the membrane all show up on the same written estimate.
What a Curbless Shower Costs in El Monte
For El Monte, a curbless shower project typically runs $9,000-$28,000 as part of a full bathroom remodel, and a walk-in shower installation alone runs $4,500-$12,000. The concrete work, drain relocation, and waterproofing are what separate a curbless quote from a standard shower replacement, which lands at $3,000-$8,500. Here’s how the line items break out:
| Scope | Typical El Monte range |
|---|---|
| Full bathroom remodel (including curbless shower) | $9,000-$28,000 |
| Walk-in shower installation | $4,500-$12,000 |
| Tub-to-shower conversion | $3,500-$10,000 |
| Standard shower replacement (curbed) | $3,000-$8,500 |
| Small bathroom remodel | $5,000-$12,000 |
| Vanity installation | $800-$3,000 |
Slab cutting, drain relocation, and permit fees are the biggest swing factors. A raised-foundation home with an accessible drain line can come in near the low end. A 1950s slab home with a cast-iron drain and a bathroom that needs re-tiling wall to wall lands near the high end. We offer 0% financing for 18 months and $1,000 off projects over $10,000, which makes the slab work easier to budget. For an exact figure on your bathroom, start with our Bathroom Remodeling in El Monte page or call for a free estimate and design consult.
Who a Curbless Shower Is Actually For
Curbless showers satisfy ADA clearance guidelines for a zero-threshold entry, which matters for aging-in-place and for anyone using a walker or wheelchair. In El Monte, where a lot of owner-occupied homes have been held by the same household for decades, future-proofing a bathroom is a common reason to call. It’s also the practical choice for a hall bath shared by a growing family, or for a small bathroom where a curb eats the only floor space you have.
They’re not free of tradeoffs. Water containment depends entirely on the slope and drain placement, so a poorly built one splashes out onto the bathroom floor. A linear drain along one wall usually handles the drainage better than a center drain in a long, narrow bath. If you’re weighing options, our Bathroom Remodeling service page covers the full scope, and our home page shows the materials and brands we bring to every trade.
Common Local Scenarios We Run Into
- 1955 slab bungalow, original cast-iron drain. The curbless pan needs a recessed drain, but the existing line is corroded. We scope the drain replacement with the concrete cut so there’s no surprise mid-project.
- Owner converting a tub to a walk-in shower for an aging parent. The zero-threshold entry and grab-bar blocking go in before the tile, and the ADA clearances get checked on the plan.
- Small hall bath in a postwar tract home. Removing the curb opens up floor space, and a linear drain along one wall keeps the water moving without a center-drain bulge.
- Garage-conversion bathroom on a compact lot. New drain lines tie into a raised or re-poured slab, so the elevation gets worked out with the plumbing rough-in first.
- Infill remodel near the corridors. Second-story or addition bathrooms need a framing check before we commit to a curbless drain location.
The hot, dry San Gabriel Valley summers don’t affect the shower build itself, but they do push homeowners toward tile and stucco finishes that hold up over the long term, and that affects what goes on the walls around the shower.
FAQs
A curbless shower has no raised lip at the entry, so the bathroom floor meets the shower floor at the same level and water drains through a recessed linear or center drain. The difference from a regular shower is the drain height: a curbed shower hides its drain inside a framed platform, while a curbless one requires the drain set below finished floor level and the entire wet area sloped at 1/4 inch per foot. On a slab home in El Monte, that means cutting concrete. Call (888) 271-7872 and we’ll tell you whether your floor allows it.
Yes. Any slab penetration for a new drain line triggers a plumbing permit and inspection with the City of El Monte, and plan-check reviews the scope before the permit is issued. Groundwork Construction Co. of El Monte pulls that permit as part of the project and prices it upfront, so it isn’t a surprise line item later. If you want to know what your specific bathroom will require, call for a free estimate.
Almost always, yes – we cut and remove a section of slab, recess the drain, and rebuild the sloped pan before waterproofing. The main variable is the condition of the existing drain line once we expose it; older cast-iron or clay lines often need replacement at the same time. Our technicians have up to 12 years of experience on exactly this kind of concrete and waterproofing work. Call (888) 271-7872 for a no-pressure assessment.
Yes. A zero-threshold entry satisfies ADA clearance guidelines, which makes it the practical choice if anyone in the household uses a walker or wheelchair, or if you plan to stay in the home long term. We add grab-bar blocking and check clearances before tile goes down. To plan one for your El Monte bathroom, call for a free design consult.
Get Your El Monte Bathroom on Solid Ground
If you’d rather have it looked at, Groundwork Construction Co. of El Monte offers a no-pressure assessment in El Monte – call (888) 271-7872. We’ll check your foundation, the drain line, and the permit scope, then give you an upfront price before any work starts. Live person on the line, 24/7. Our technicians have up to 12 years of experience, and every project is backed by the 730-Day Done Right Promise: if it’s not done right, we make it right.
Written by the team at Groundwork Construction Co. of El Monte, serving El Monte, CA.


